IBM 4332-004 User Guide - Page 148

Coax Setup Menu Item Value EAB ENABLE* DISABLE BUFFERSIZE EARLY COMPL 960 1920* 2560 3440 3564 ON* OFF Description Enables or disables the extended attribute buffer support. Note: The EAB menu item also enables or disables the ability to print IPDS jobs over the coax attachment. Specifies the buffer size in bytes. Turns early print completion on or off for non-IPDS data sent over the coax attachment. To turn early print completion on or off for IPDS data, use the EARLY COMPL item on the IPDS Menu. v ON-sends an "order complete" as soon as data is received. v OFF-waits until the print job is physically complete to send "order complete." Twinax Setup Menu Use the Twinax Setup Menu to configure the twinax attachment. The following table describes the settings you can change from the Twinax Setup Menu. An asterisk (*) next to a value in the table indicates the factory default. The Twinax Setup Menu appears only if you have the twinax network interface card installed. Notes: 1. To select a new value, press the Enter key when the value is displayed in the message display area. An asterisk (*) appears next to the value in the message display area, indicating that it is now active. Important! If you change SCS ADDR or IPDS ADDR, you must power off the printer, wait ten seconds, and then power on the printer for the new value to take effect. 2. For more information about configuring the twinax attachment, see Twinax/Coax Configuration Guide. 3. If you are unfamiliar with using the operator panel to work with menus, please read "Using the Operator Panel Keys" on page 23 and "Navigating Menus" on page 24 before continuing. 136 Infoprint 32 and Infoprint 40: User's Guide