IBM 4332-004 User Guide - Page 184

The Network Interface Card The printer attaches to networks and other system configurations through these optional cards: v IBM Network Card for Ethernet (10BaseT/10Base2) v IBM Network Card for Ethernet (100BaseTx) v IBM Network Card for Token Ring v IBM Twinax SCS Interface Card v IBM Coax SCS Interface Card If you have purchased optional network interface cards for your printer, install them in the printer following the steps listed in this section. Two cards to connect to two different systems can be installed. Note: You cannot install two identical cards. For example, the printer cannot accept two IBM Network Cards for Ethernet, but can accept an IBM Ethernet card and an IBM Token-Ring card. A system or network administrator should review the documentation shipped with the network interface card to configure the printer and your computing environment correctly. Ethernet and Token Ring Quick Configuration Guide is shipped with the Ethernet and token-ring network interface cards. Twinax/Coax Configuration Guide is shipped with the Twinax and Coax network interface cards. Only a system or network administrator should configure your network computing environment for this printer. Installing a Network Interface Card Important! Follow the instructions for handling static-sensitive devices described on page 165. Use the following procedure to install a network interface card: 1. Unpack the network interface card, and set aside the software and documentation that arrived with the card. 2. If you are installing a token-ring card, you must complete the following procedure to set the line speed for the card. If you are not installing a token-ring card, skip this step and go to Step 3. 172 Infoprint 32 and Infoprint 40: User's Guide