IBM 4332-004 User Guide - Page 146

Twinax SCS Menu Item Value APO ENABLE* DISABLE Description Enables or disables automatic print orientation. v ENABLE-if the requested dimensions of the job fit on the paper, the page is printed either in portrait or landscape, whichever better fits the dimensions. If the requested dimensions do not fit on the paper, the default orientation for the tray (COR, PORT, LAND, or C-PORT) determines how the sheet is printed. v DISABLE-the page prints using the default orientation for the tray (COR, PORT, LAND, or C-PORT). Notes: 1. Values specified in the data stream override values set at the printer. 2. The factory defaults (orientation set to COR and APO=ENABLE) give you the most flexibility. 3. The requested dimensions are determined by the values of CPI, LPI, MPP, and MPL for the job. These values can be set in the data stream. CPI and LPI can be set on the Twinax SCS menu. The twinax default values for MPP and MPL cannot be set from a menu; they are 132 for MPP and 62 for MPL. Coax Setup Menu Use the Coax Setup Menu to configure the coax attachment. The following table describes the settings you can change from the Coax Setup Menu. An asterisk (*) next to a value in the table indicates the factory default. The Coax Setup Menu appears only if you have the coax network interface card installed. Notes: 1. To select a new value, press the Enter key when the value is displayed in the message display area. An asterisk (*) appears next to the value in the message display area, indicating that it is now active. 2. For more information about configuring the coax attachment, see Twinax/Coax Configuration Guide. 3. If you are unfamiliar with using the operator panel to work with menus, please read "Using the Operator Panel Keys" on page 23 and "Navigating Menus" on page 24 before continuing. 134 Infoprint 32 and Infoprint 40: User's Guide