IBM 4332-004 User Guide - Page 238

8. If the problem involves spots or streaks, print several test pages to clean out contamination. 9. If the problem is with complex graphics or images and the message MRT COMPRESSION displays, try changing the PAGEPROT menu item to ON. This item can be individually set in specific data stream menus (PCL Menu, PS Menu, or IPDS Menu.) You may also need more memory. See "Memory Requirements" on page 8 for information about memory requirements. 10. If you have an EDGE-EDGE setting set to ON, set it to OFF. EDGE-EDGE can be found on the following menus: v "PCL Menu" on page 106 v "PS Menu" on page 110 v "Coax Setup Menu" on page 134 v "Twinax Setup Menu" on page 136 v "IPDS Menu" on page 111 11. Consider replacing the fuser. See "Changing the Usage Kit" on page 152. Print Is Too Light Possible Causes Economy mode is set on. Density is set too low. There is moisture in the paper. The toner cartridge is low on toner. The toner cartridge is damaged or life exceeds 23,000 pages. Actions You Should Take Print Sample Make sure economy mode is not set. Check your print driver settings and also see "Configuration (Config) Menu" on page 102. Reset it to a higher value if necessary. See "Configuration (Config) Menu" on page 102. Load fresh, dry paper. Replace the toner cartridge. See "Changing the Toner Cartridge" on page 144. Replace the toner cartridge. See "Changing the Toner Cartridge" on page 144. 226 Infoprint 32 and Infoprint 40: User's Guide