IBM JS20 Hardware Maintenance Manual - Page 110
SDR1-base
UPC - 000435230263
View all IBM JS20 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 110 highlights
Checkpoint FRU/action E20B (Reading boot mode) 1. Go to "Checkout procedure" on page 38. Note: If you have already been through the checkout procedure, continue with step 2. 2. System board and chassis. E20C (Finished hardware probing; 1. Go to "Checkout procedure" on page 38. passing control to partition firmware) 2. System board and chassis. E20D (Boot mode has been obtained) 1. Go to "Checkout procedure" on page 38. 2. System board and chassis. E20F (Executing from L2 cache) 1. Go to "Checkout procedure" on page 38. 2. System board and chassis. E210 (Load and relocate the HIL) 1. Go to "Checkout procedure" on page 38. 2. System board and chassis. E211 (CRC check of the image in flash RAM) 1. Go to "Checkout procedure" on page 38. 2. System board and chassis. E212 (Getting CPU status and presence) 1. Go to "Checkout procedure" on page 38. 2. System board and chassis. E213 (Memory initialization) 1. Verify that DIMMs are correctly installed and seated, then restart server. 2. Start server from backup flash to recover primary image. 3. System board and chassis. E214 (Pattern 1 memory test) 1. Verify that DIMMs are correctly installed and seated, then restart server. 2. Start server from backup flash to recover primary image. 3. System board and chassis. E215 (Pattern 2 memory test) 1. Verify that DIMMs are correctly installed and seated, then restart server. 2. Start server from backup flash to recover primary image. 3. System board and chassis. E216 (Clear memory) 1. Verify that DIMMs are correctly installed and seated, then restart server. 2. Start server from backup flash to recover primary image. 3. System board and chassis. E217 (Start DART, HIL-base, and SDR1-base) 1. Go to "Checkout procedure" on page 38. 2. System board and chassis. E218 (Copying the set of flash RAM 1. Go to "Checkout procedure" on page 38. to memory) 2. System board and chassis. E219 (Saving the DIMM SPDs and the CPU status and presence) 1. Go to "Checkout procedure" on page 38. 2. System board and chassis. E21A (Executing code from memory) 1. Go to "Checkout procedure" on page 38. 2. System board and chassis. E21B (Load PFW into memory) 1. Go to "Checkout procedure" on page 38. 2. System board and chassis. E21C (Executing HT initialization) 1. Go to "Checkout procedure" on page 38. 2. System board and chassis. 100 BladeCenter JS20 Type 8842: Hardware Maintenance Manual and Troubleshooting Guide