IBM JS20 Hardware Maintenance Manual - Page 92
Ethernet, controller, switch, module, cabling, requirements
UPC - 000435230263
View all IBM JS20 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 92 highlights
Note: For device driver and configuration information to complete the installation of the I/O expansion card, see the documentation that comes with the card. Some documentation might also be on the IBM BladeCenter Documentation CD that comes with the BladeCenter unit. For the latest editions of the IBM BladeCenter documentation, go to http://www.ibm.com/support/ on the World Wide Web. 8. If you have other options to install or remove, do so now; otherwise, go to "Completing the installation" on page 90. Ethernet controller, switch module, and cabling requirements One dual-port Gigabit Ethernet controller is integrated on the BladeCenter JS20 Type 8842 system board. To support Ethernet connections and the Serial Over LAN (SOL) feature and to configure the blade server, you must install an optional Ethernet-compatible switch module, such as the Nortel Networks Layer 2-7 GbE Switch Module for IBM BladeCenter or IBM 4-Port Gb Ethernet Switch Eserver Module for BladeCenter, in I/O bay 1 of the BladeCenter unit. Each controller port provides a 1000-Mbps full-duplex interface for connecting to one of the Ethernet-compatible switch modules in I/O bays 1 and 2. If you plan to attach additional Ethernet devices to the blade server or the BladeCenter unit, you must install an optional Ethernet-compatible switch module, such as the Nortel Networks Layer 2-7 GbE Switch Module for IBM BladeCenter or IBM Eserver 4-Port Gb Ethernet Switch Module for BladeCenter, in I/O bay 3 or 4 of the BladeCenter unit, to support these additional Ethernet connections. The optional Ethernet switch modules contain four ports with RJ-45 connectors. These connectors provide a 10/100/1000 Base-T interface (either at half-duplex or full duplex) for connecting twisted-pair cable to the Ethernet network. You must purchase and install a compatible cable to connect these devices. To connect an Ethernet controller port to a repeater or switch module, use an unshielded twisted pair (UTP) cable with RJ-45 connectors at both ends. For 100 Mbps or higher operation, Category 5 cabling is required. For 10 Mbps operation, Category 3 or Category 5 cabling is required. Notes: v For more information about Ethernet requirements, see the documentation that comes with the Ethernet devices and the BladeCenter Type 8677 Installation and User's Guide. v For more information about installing, configuring, and using the Ethernet switch modules, see the documentation that comes with the Ethernet switch module that you are using, such as the IBM 4-Port Gb Ethernet Switch Module for BladeCenter Installation and User's Guide or Nortel Networks Layer 2-7 GbE Switch Module for IBM BladeCenter Installation Guide. v For more information about the SOL feature, see Chapter 3, "Configuration," on page 17, the IBM BladeCenter and BladeCenter T Serial Over LAN Eserver Setup Guide, and the BladeCenter and BladeCenter T Management Module Command-Line Interface Reference Guide. 82 BladeCenter JS20 Type 8842: Hardware Maintenance Manual and Troubleshooting Guide