IBM JS20 Hardware Maintenance Manual - Page 91
power-control
UPC - 000435230263
View all IBM JS20 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 91 highlights
The following illustration shows how to install an I/O expansion card on the blade server. The card is installed near IDE connector 2. IBM I/O expansion card INPSRTAELSLSINHGERCEARWDHEN I/O expansion tray Raised hook I/O expansion card connector Short screws I/O expansion card connector Complete the following steps to install an I/O expansion card: 1. Read the safety information beginning on page iii and "Installation guidelines" on page 71 2. If the blade server is operating, shut down the operating system by typing the shutdown -h now command. Refer to your operating system documentation. If the blade server was not turned off, press the power-control button (behind the blade-server control-panel door) to turn off the blade server. See "Blade server controls and LEDs" on page 14 for more information about the location of the power-control button. 3. Remove the blade server from the BladeCenter unit (see "Removing the blade server from the BladeCenter unit" on page 73 for information). 4. Carefully place the blade server on a flat, static-protective surface. 5. Open the cover (see "Opening the blade server cover" on page 74 for instructions). 6. Install the I/O expansion card tray: a. If there is no IDE hard disk drive in IDE connector 2, remove the four screws as shown in the previous illustration. Then, continue with step 6c. b. If an IDE hard disk drive is in IDE connector 2, remove the hard disk drive and tray. Save the four long screws that secured the tray to the system board. Remove the riser card that connected the IDE hard disk drive to the blade server system board. c. Secure the tray to the system board with the screws from the option kit, as shown in the previous illustration. 7. Install the I/O expansion card: a. Orient the I/O expansion card as shown in the previous illustration. b. Slide the notch in the narrow end of the card into the raised hook on the tray; then, gently pivot the wide end of the card into the I/O expansion card connectors, as shown in the previous illustration. Chapter 9. Installing options 81