IBM JS20 Hardware Maintenance Manual - Page 148
IBM JS20 - BladeCenter - 8842 Manual
UPC - 000435230263
View all IBM JS20 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 148 highlights
Service request number A15-24x A15-50x A1D-00x A1D-02x A1D-04x A1D-05x A1D-06x SRN source Description FRU/action G Power Fault specifically due to internal 1. Check the BladeCenter management module battery failure. event log; if an error was recorded by the system or if a checkpoint code is displayed on the console, see Chapter 10, "Symptom-to-FRU index," on page 93. 2. If no entry is found, replace the system board. G Recoverable errors on resource indicate 1. If repair is not immediately available, reboot a trend toward an unrecoverable error. and the resource will be deconfigured; However, the resource could not be operations can continue in a degraded mode. deconfigured and is still in use. The system is operating with the potential for an unrecoverable error. 2. Check the BladeCenter management module event log; if an error was recorded by the system or if a checkpoint code is displayed on the console, see Chapter 10, "Symptom-to-FRU index," on page 93. 3. If no entry is found, replace the system board. G A non-critical error has been detected. 1. Check the BladeCenter management module Error log analysis indicates an error event log; if an error was recorded by the detected by the Service Processor, but system or if a checkpoint code is displayed on the failure could not be isolated. the console, see Chapter 10, "Symptom-to-FRU index," on page 93. 2. If no entry is found, replace the system board. G A non-critical error has been detected, an 1. Check the BladeCenter management module I/O (I2C) general bus error. event log; if an error was recorded by the system or if a checkpoint code is displayed on the console, see Chapter 10, "Symptom-to-FRU index," on page 93. 2. If no entry is found, replace the system board. G A non-critical error has been detected, an 1. Check the BladeCenter management module internal service processor memory error. event log; if an error was recorded by the system or if a checkpoint code is displayed on the console, see Chapter 10, "Symptom-to-FRU index," on page 93. 2. If no entry is found, replace the system board. G A non-critical error has been detected, a 1. Check the BladeCenter management module service processor error accessing special event log; if an error was recorded by the registers. system or if a checkpoint code is displayed on the console, see Chapter 10, "Symptom-to-FRU index," on page 93. 2. If no entry is found, replace the system board. G A non-critical error has been detected, a 1. Check the BladeCenter management module service processor reports unknown event log; if an error was recorded by the communication error. system or if a checkpoint code is displayed on the console, see Chapter 10, "Symptom-to-FRU index," on page 93. 2. If no entry is found, replace the system board. 138 BladeCenter JS20 Type 8842: Hardware Maintenance Manual and Troubleshooting Guide