IBM JS20 Hardware Maintenance Manual - Page 96
System, board, component, locations
![]() |
UPC - 000435230263
View all IBM JS20 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 96 highlights
System board Two operational microprocessors and heat sinks are required on the system board in the blade server at all times. The microprocessors and heat sinks are not replaceable. Do not attempt to remove these components or any components that secure the microprocessors and heat sinks to the system board. You must replace the system board if any of these conditions exists: v A microprocessor or heat sink becomes defective. v Certain errors occur as described in "Firmware error codes" on page 102. v The blade server does not restart after you recover the system firmware code as described in "Recovering the system firmware code" on page 54. To obtain a new system board, you must order a new blade server. The replacement system board comes attached to the new blade server. To order a blade server, contact your IBM authorized reseller or IBM marketing representative. Important: After you replace the system board, you must either update the new blade server with the latest firmware or restore the pre-existing firmware from a diskette or CD image. You must also reconfigure the new blade server and reset the system date and time. System board component locations The following illustration shows the location of the system-board components, including connectors for user-installable options. Note: All jumpers not specifically mentioned are reserved. 86 BladeCenter JS20 Type 8842: Hardware Maintenance Manual and Troubleshooting Guide
![](/manual_guide/products/ibm-js20-hardware-maintenance-manual-7a4946f/96.png)