IBM JS20 Hardware Maintenance Manual - Page 131

Service request number 2D02 SRN source G Failing Function Code 2631 Description and action Generic reference for USB controller/adapter - system planar see "FFC table" on page 142, FFC 2631 SRNs A00-(x)xxx through A1D-(x)xxx Note: Some SRNs in this chapter may have 4 rather than 3 digits after the dash (-). The x in an SRN will have a value of 1, 2, 4, or 8, with a meaning as follows: Number 1 2 4 8 Meaning Replace all FRUs listed Hot swap supported Software might be the cause Reserved The SRN source identifies the program or procedure that produced the SRN, with values as follows: Code D E G Source of SRN This SRN is from a diagnostic test after complete isolation testing. This SRN is from a POST failure. This SRN is from an Error Log Analysis program Service request number A00-FF0 A01-00x A01-01x SRN source Description G Error log analysis is unable to determine the error. The error log indicates the following physical FRU locations as the probable causes. G Error log analysis indicates an error detected by the CPU, but the failure could not be isolated. G G CPU internal error. FRU/action 1. Check the BladeCenter management module event log; if an error was recorded by the system or if a checkpoint code is displayed on the console, see Chapter 10, "Symptom-to-FRU index," on page 93. 2. If no entry is found, replace the system board. 1. Check the BladeCenter management module event log; if an error was recorded by the system or if a checkpoint code is displayed on the console, see Chapter 10, "Symptom-to-FRU index," on page 93. 2. If no entry is found, replace the system board. 1. Check the BladeCenter management module event log; if an error was recorded by the system or if a checkpoint code is displayed on the console, see Chapter 10, "Symptom-to-FRU index," on page 93. 2. If no entry is found, replace the system board. Chapter 10. Symptom-to-FRU index 121