IBM JS20 Hardware Maintenance Manual - Page 85
Removing, blade, server, bezel, assembly, Installing, drives
UPC - 000435230263
View all IBM JS20 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 85 highlights
Removing the blade server bezel assembly Before you can replace a defective system-board assembly or blade-server bezel assembly, you must first remove the blade-server bezel assembly. The following illustration shows how to remove the bezel assembly from a blade server. Bezel-assembly release Bezel-assembly release Control panel connector Control-panel cable Complete the following steps to remove the blade-server bezel assembly: 1. Read the safety information beginning on page iii and "Installation guidelines" on page 71 2. Open the blade server cover. 3. Press the bezel-assembly release and pull the bezel assembly away from the blade server approximately 1.2 cm (0.5 inch). 4. Disconnect the control-panel cable from the control-panel connector. 5. Pull the bezel assembly away from the blade server. 6. Store the bezel assembly in a safe place. Installing IDE hard disk drives The blade server has two connectors on the system board for installing optional 2.5-inch integrated drive electronics (IDE) hard disk drives. Each IDE connector is on a separate channel. Some models come with at least one IDE hard disk drive already installed. Note: Some hard disk drives have Phillips screws; therefore, make sure that a Phillips screwdriver is available. Attention: To maintain proper system cooling, do not operate the BladeCenter unit for more than 1 minute without a blade server or filler blade installed in each blade bay. Chapter 9. Installing options 75