Icom IC-7800 Instruction Manual - Page 129

9 SCANS I Programmed scan operation [SQL] for main [F-1•PROG] [EXIT/SET] Main dial q Push [EXIT/SET] several times to close a multi-func- tion screen, if necessary. w Select VFO mode. e Select the desired operating mode. • The operating mode can also be changed while scan- ning. r Push [F-5•SCAN] to select the scan screen. t Set the main band's [SQL] open or closed. • See page 9-2 for squelch condition. y Push [F-1•PROG] to start the programmed scan. •" " and decimal points blink while scanning. u When the scan detects a signal, the scan stops, pauses or ignores it depending on the resume set- ting and the squelch condition. i To cancel the scan, push [F-1•PROG]. • Rotating the main dial also cancels the scan. oPush [F-6•RECALL] for 1 sec. to recall the fre- quency that is set before starting the scan, if de- sired. If the same frequencies are programmed into the scan edge memory channel P1 and P2, programmed scan does not start. I ∂F scan operation [F-4•∂F SPAN] [SQL] for main [F-2•∂F] [EXIT/SET] Main dial q Push [EXIT/SET] several times to close a multi-func- tion screen, if necessary. w Select VFO mode or a memory channel. e Select the desired operating mode. • The operating mode can also be changed while scan- ning. r Push [F-5•SCAN] to select the scan screen. t Set the main band's [SQL] open or closed. • See page 9-2 for squelch condition. y Set the ∂F span by pushing [F-4•∂F SPAN]. • ±5 kHz, ±10 kHz, ±20 kHz, ±50 kHz, ±100 kHz, ±500 kHz and ±1000 kHz are selectable. u Set center frequency of the ∂F span. i Push [F-2•∂F] to start the ∂F scan. •" " and decimal points blink while scanning. o When the scan detects a signal, the scan stops, pauses or ignores it depending on the resume set- ting and the squelch condition. !0 To cancel the scan, push [F-2•∂F]. • Rotating the main dial also cancels the scan. !1 Push [F-6•RECALL] for 1 sec. to recall the fre- quency that is set before starting the scan, if de- sired. 9-4