Netgear FS728TPv2 FS728TP Software Administration Manual - Page 117

FS728TP Smart Switch Software Administration Manual • Interface: Select Interface from the menu, enter the interface ID in e1, e2... format, then, click Go. If any entries learned on that interface exist, they are displayed. 2. Click Clear to clear Dynamic MAC Addresses in the table. 3. Click Refresh to redisplay the page to show the latest MAC Addresses. 4. Click Cancel to cancel the configuration on the screen and reset the data on the screen to the latest value of the switch. The following table describes the information available for each entry in the address table. Field VLAN ID MAC Address Interface Status Description Specifies the VLAN ID on which the IGMP Snooping Querier is administratively enabled and for which VLAN exists in the VLAN database. A unicast MAC address for which the switch has forwarding and/or filtering information. The format is a six-byte MAC address with each byte separated by colons. For example, 00:0F:89:AB:CD:EF. The port where this address was learned: that is, this field displays the port through which the MAC address can be reached. The status of this entry. The possible values are: • Static: The entry was added when a static MAC filter was defined. • Learned: The entry was learned by observing the source MAC addresses of incoming traffic, and is currently in use. • Management: The system MAC address, which is identified with interface c1. Dynamic Address Configuration Use the Dynamic Addresses page to set the amount of time to keep a learned MAC address entry in the forwarding database. The forwarding database contains static entries, which are never aged out, and dynamically learned entries, which are removed if they are not updated within a given time. To access the Configuration page, click Switching  Address Table  Advanced  Dynamic Addresses. Chapter 3: Configuring Switching Information | 117