Netgear FS728TPv2 FS728TP Software Administration Manual - Page 92
Spanning Tree State, STP Operation Mode, Configuration Name, Configuration Revision Level, Cancel
View all Netgear FS728TPv2 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 92 highlights
FS728TP Smart Switch Software Administration Manual To configure STP settings on the switch: 1. From the Spanning Tree State field, specify whether to enable or disable Spanning Tree operation on the switch. 2. From the STP Operation Mode field, Specifies the Force Protocol Version parameter for the switch. Options are: • STP (Spanning Tree Protocol): IEEE 802.1D • RSTP (Rapid Spanning Tree Protocol): IEEE 802.1w • MSTP (Multiple Spanning Tree Protocol): IEEE 802.1s 3. Specify the configuration name and revision level. • Configuration Name. Name used to identify the configuration currently being used. It may be up to 32 alphanumeric characters. • Configuration Revision Level. Number used to identify the configuration currently being used. The values allowed are between 0 and 65535. The default value is 0. 4. Specify the BPDU Flooding status for all ports or for individual ports. When this feature is enabled, BPDU packets arriving at this port are flooded to other ports if STP is disabled. 5. Click Cancel to cancel the configuration on the screen and reset the data on the screen to the latest value of the switch 6. If you make any configuration changes, click Apply to send the updated configuration to the switch. Configuration changes occur immediately. 92 | Chapter 3: Configuring Switching Information