Netgear FS728TPv2 FS728TP Software Administration Manual - Page 195
Enable, Disable, Field, Description
View all Netgear FS728TPv2 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 195 highlights
FS728TP Smart Switch Software Administration Manual Field Description Port Channel ID If the port is a member of a port channel, the port channel's interface ID and name are shown. Otherwise, Disable is shown. Port Role Each MST Bridge Port that is enabled is assigned a Port Role for each spanning tree. The port role will be one of the following values: Root Port, Designated Port, Alternate Port, Backup Port, Master Port, or Disabled Port. STP Mode Displays the Spanning Tree Protocol (STP) Administrative Mode for the port or LAG. The possible values for this field are: • Enable: Enables the Spanning Tree Protocol for this port. • Disable: Disables the Spanning Tree Protocol for this port. STP State Displays the port's current state Spanning Tree state. This state controls what action a port takes on receipt of a frame. If the bridge detects a malfunctioning port it will place that port into the broken state. The other five states are defined in IEEE 802.1D: • Disabled • Blocking • Listening • Learning • Forwarding • Broken Admin Mode Displays the port control administration state: • Enable: The port can participate in the network (default). • Disable: The port is administratively down and does not participate in the network. LACP Mode Selects the Link Aggregation Control Protocol administration state: • Enable: Specifies that the port is allowed to participate in a port channel (LAG), which is the default mode. • Disable: Specifies that the port cannot participate in a port channel (LAG). Physical Mode Indicates the port speed and duplex mode. In auto-negotiation mode, the duplex mode and speed are set from the auto-negotiation process. Physical Status Indicates the port speed and duplex mode status. Link Status Indicates whether the link is up or down. Link Trap This object determines whether or not to send a trap when link status changes. The factory default is Enable. • Enable: Specifies that the system sends a trap when the link status changes. • Disable: Specifies that the system does not send a trap when the link status changes. Packets RX and TX 64 Octets The total number of packets (including bad packets) received or transmitted that were 64 octets in length (excluding framing bits but including FCS octets). Packets RX and TX 65-127 The total number of packets (including bad packets) received or transmitted Octets that were between 65 and 127 octets in length inclusive (excluding framing bits but including FCS octets). Chapter 6: Monitoring the System | 195