Netgear FS728TPv2 FS728TP Software Administration Manual - Page 80
LACP Configuration, Switching, Advanced, Refresh, Cancel, Apply
View all Netgear FS728TPv2 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 80 highlights
FS728TP Smart Switch Software Administration Manual LACP Configuration To display the LACP Configuration page, click Switching LAG Advanced LACP Configuration. To configure LACP: 1. From the LACP System Priority field, specify the device's link aggregation priority relative to the devices at the other ends of the links on which link aggregation is enabled. A higher value indicates a lower priority. You can change the value of the parameter globally by specifying a priority from 0-65535. The default value is 32768. 2. Click Refresh to reload the page and display the most current information. 3. Click Cancel to cancel the configuration on the screen and reset the data on the screen to the latest value of the switch. 4. If you make any changes to this page, click Apply to send the updated configuration to the switch. Configuration changes take effect immediately. 80 | Chapter 3: Configuring Switching Information