Netgear FS728TPv2 FS728TP Software Administration Manual - Page 123

FS728TP Smart Switch Software Administration Manual To configure global CoS settings: 1. Select the Global radio button to configure the trust mode settings that apply to all interfaces. Alternatively, you can select the Interface radio button to apply trust mode settings to individual interfaces. The per-interface setting overrides the global settings. 2. Select the trust mode for all interfaces (Global Trust Mode) or the selected interface (Interface Trust Mode). This setting determines the type of CoS marking to trust when the frame enters the port. • Untrusted. Do not trust any CoS packet marking at ingress. • 802.1p. The switch supports eight hardware priority queues. For information about mapping IEEE 802.1p priorities to the switch hardware priority queues, see 802.1p to Queue Mapping on page 126. • DSCP. The six most significant bits of the DiffServ field are called the Differentiated Services Code Point (DSCP) bits. For information about mapping DSCP values to the switch hardware priority queues, see DSCP to Queue Mapping on page 127. • 3. Click Cancel to cancel the configuration on the screen and reset the data on the screen to the latest value of the switch. 4. If you change any of the settings on the page, click Apply to send the updated configuration to the switch. CoS Interface Configuration Use the CoS Interface Configuration page to apply an interface shaping rate to all interfaces or to a specific interface. To display the CoS Interface Configuration page, click the QoS  CoS tab, and then click the Advanced  CoS Interface Configuration link. Chapter 4: Configuring Quality of Service | 123