Netgear FS728TPv2 FS728TP Software Administration Manual - Page 227
Traceroute, Maintenance, Troubleshooting, Hostname/IP Address, Probes Per Hop, MaxTTL, InitTTL
View all Netgear FS728TPv2 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 227 highlights
FS728TP Smart Switch Software Administration Manual • If successful, you will see "Reply From IP/Host: icmp_seq = 0. time = xx usec. Tx = x, Rx = x Min/Max/Avg RTT = x/x/x msec." • If a reply to the ping is not received, you will see "Reply From IP/Host: Destination Unreachable. Tx = x, Rx = 0 Min/Max/Avg RTT = 0/0/0 msec". Traceroute Use the Traceroute utility to discover the paths that a packet takes to a remote destination. To display this page, click Maintenance Troubleshooting Traceroute. To configure the Traceroute settings and send probe packets to discover the route to a host on the network: 1. In the Hostname/IP Address field, specify the IP address or the hostname of the station you want the switch to ping. The initial value is blank. This information is not retained across a power cycle. 2. Optionally, configure the following settings: • Probes Per Hop. Specify the number of times each hop should be probed. The valid range is 1-10. • MaxTTL. Specify the maximum time-to-live for a packet in number of hops. The valid range is 1-255. • InitTTL. Specify the initial time-to-live for a packet in number of hops. The valid range is 0- 255. • MaxFail. Specify the maximum number of failures allowed in the session. The valid range is 0-255. • Interval. Specify the time between probes in seconds. The valid range is 1-60. Chapter 7: Maintenance | 227