Sharp BP-70C36 Color Advanced and Essentials BP Series Operating Manual - Page 1007

TROUBLESHOOTING►GENERAL PROBLEMS Check Has an appropriate exposure mode for the original type been selected? Is the overall copy density too light?  Solution ■ Select one of the following modes depending on the original type. (This can be set in normal mode.) • Text  Use this mode for regular text documents. • Text/Printed Photo  This mode provides the best balance for copying an original which contains both text and printed photographs, such as a magazine or catalogue. • Text/Photo  This mode provides the best balance for copying an original which contains both text and photographs, such as a text document with a photo pasted on. • Printed Photo  This mode is best for copying printed photographs, such as photos in a magazine or catalogue. • Photo  Use this mode to copy photos. • Map  This mode is best for copying the light color shading and fine text found on most maps. • Light Original  Use this mode for originals with light pencil writing. ■ Change the overall copy density with either method below. • Changing the default setting  Select "Settings (administrator)" - [System Settings] → [Image Quality Adjustment] → [Copy Image Quality] → [Quick Image Quality Adjustment]. Set default setting [2] to [3 (Sharp)] to increase the overall density, or [1 (Smooth)] to decrease the overall density. • Temporarily changing the setting  Select Normal Mode (the setting cannot be changed in Easy Mode). In [Others]  → [Quick Image Quality Adjustment], set default setting [2] to [3 (Sharp)] to increase the overall density, or [1 (Smooth)] to decrease the overall density. The setting is automatically reset when you return to the home screen. COLORS ARE OFF Check Did you perform "Registration Adjustment"?  Solution ■ Ask your administrator to perform "Registration Adjustment".  "Settings (administrator)" → [System Settings] → [Image Quality Adjustment] → [Collective Adjustment] → [Registration Adjustment] . If the color tones are off, perform [Auto Color Calibration (for Copy)] after finishing registration adjustment. (If the colors are still off after calibration, repeating calibration may improve the results.)  "Settings (administrator)" → [System Settings] → [Image Quality Adjustment] → [Common Functions] → [Auto Color Calibration (for Copy)] 10-24