Sharp BP-70C36 Color Advanced and Essentials BP Series Operating Manual - Page 41

BEFORE USING THE MACHINE►PERIPHERAL DEVICES INNER FINISHER This device outputs sorted paper while staggering each set of paper. As needed, it staples each set. You can also perform stapling manually. To punch holes in printed paper, install an optional hole punch module. PART NAMES The following describes the parts that appear when the finisher is open. (1) (2) (3) (4) (5) (6) (7) (8) (1) Output tray Stapled and offset output is delivered to this tray. The tray is slidable. To print on large paper such as 11" x 17" (A3) size, extend the tray. (2) Manual staple key Press to execute manual stapling. (3) Punch waste box (when a punch module is installed) This stores punch waste discharged from punching. (4) Insertion slot Place the paper that you want to staple in this slot. Maximum thickness 11/64" (4 mm). (5) Front cover Open this cover to remove a paper misfeed, replace staples, remove a staple jam, or remove the punch waste box. (6) Staple case This holds the staple cartridge. Pull the case out to replace the staple cartridge or remove a staple jam. (7) Staple case release lever Use this lever to remove the staple case. (8) Lever Use this lever to move the finisher in order to remove a paper misfeed, or remove a staple jam. • The inner finisher cannot be installed at the same time as the folding unit, finisher, finisher (large stacker), saddle stitch finisher or saddle stitch finisher (large stacker). • Exercise caution when you turn on the power and when printing take place, as the output tray may move up and down. 1-38