Sharp BP-70C36 Color Advanced and Essentials BP Series Operating Manual - Page 954

SETTING MODE►SYSTEM SETTINGS IPsec Settings IPsec can be used for data transmission/reception on a network. When IPsec is used, data can be sent and received safely without the need to configure settings for IP packet encryption in a Web browser or other higher-level application. When enabling this settings, take the following notes. • It may take some time to reflect on the machine settings, and you cannot connect to the machine during this time. • If the Setting mode (Web version) settings are not correctly selected, connection to the machine may not be allowed, or the settings may not allow printing, scanning, or Setting mode (Web version) display. In this case, deselect this setting and change the System Settings (on Web pages). Condition Settings IPsec Settings Sets whether to use IPsec for transmission. Factory default settings: Disable IKEv1 Settings Pre-Shared Key Enter the Pre-Shared Key to be used for IKEv1. SA Lifetime (time) Set the SA lifetime. Factory default settings: 28800 seconds SA Lifetime (size) Set the SA lifetime size. Factory default settings: 28800 KB IKE Lifetime Set the IKE lifetime. Factory default settings: 30 seconds IPsec Rules The registered IPsec rules are displayed. To add a new rule, click the [Add] key. To delete a rule, select the rule you want to delete and click the [Delete] key. IPsec Rule Registration Rule Name Enter a name for the IPsec rule. Priority Set the priority level. Factory default settings:1 Select the Rule Name to be the Registration Model If there is a previously registered rule that is similar to the rule you want to create, you can create the new rule based on the registered rule. Device Address Set the type of IP address to be used on the machine and the port number (for IPv6, set the port number / prefix length). Client Address Set the destination IP address type and port number (for IPv6, set the port number / prefix length). 9-180