Sharp BP-70C36 Color Advanced and Essentials BP Series Operating Manual - Page 911

SETTING MODE►SYSTEM SETTINGS Key Operation Setting Auto Clear Setting The time until Auto Clear activates can be set to any number of seconds from 10 to 240 in increments of 10 seconds. If the machine is not used for the duration of time set here, the auto clear function will clear any settings that have been selected and return the screen to the base screen of copy mode or the job status screen. Factory default settings: 60 seconds Cancel Timer This is used to disable the auto clear function. Factory default settings: Disable Key Operation Setting Time for Accepting Key Entry This setting determines how long a key in the touch panel must be tapped until the key input is registered. The time can be set from 0 to 2 seconds in increments of 0.5 seconds. By lengthening the time setting, key input can be prevented when a key is tapped accidentally. Keep in mind, however, that when a longer setting is selected more care is required when tapping keys to ensure that key input is registered. Factory default settings: 0.0 seconds Disable Auto Key Repeat This is used to disable key repeat. Factory default settings: Disable Key repeat causes a setting to change continuously not only each time the key is tapped but while a key is tapped. Time for Accepting Key Entry of Long Touch Select a time when a long key touch is detected. Factory default settings: 0.5 seconds Double Tap Interval Setting Select an interval when a double tap is detected. Factory default settings: 0.5 seconds Disabling of Bypass Printing This setting is used to disable bypass printing (printing other jobs ahead of a job that has been stopped *because the paper required for the job is not available in any of the trays). * This does not include cases where the paper ran out during the job. Factory default settings: Disable Priority of Print Jobs Set the priority for each job and start printing from the job with the highest priority. Factory default settings: All Low Disabling of Covers/Inserts Mode Disables the use of the covers and inserts function. Disabling Recent Jobs Prohibit the use of [Recent Jobs]. Factory default settings: Disable 9-137