ZyXEL P-870MH-C1 User Guide - Page 80
The Internet Connection Screen
View all ZyXEL P-870MH-C1 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 80 highlights
Chapter 5 WAN Setup 5.6 The Internet Connection Screen Use this screen to change your Device's WAN settings. Click Network > WAN > Internet Connection. The summary table shows you the configured WAN services (connections) on the Device. To use NAT, firewall or IGMP proxy in the Device, you need to configure a WAN connection with PPPoE or IPoE. Note: When a layer-2 interface is in VLAN MUX Mode, you can configure up to eight WAN services for each interface. Figure 33 Internet Connection The following table describes the labels in this screen. Table 13 Internet Connection LABEL DESCRIPTION Interface This shows the name of the interface used by this connection. A default name ipoa*, pppoa*, atm* or ptm* indicates DSL port. The pppx name (where x starts from 0 and is the index number of PPP connection on the Device) indicates a PPP connection via any one of the WAN interface. The number after the dot (.) represents the VLAN ID number assigned to traffic sent through this connection. The number after the underscore (_) represents the index number of connections through the same interface. Description (null) means the entry is not valid. This is the service name of this connection. 0 and 35 or 0 and 1 are the default VPI and VCI numbers. The last number represents the index number of connections over the same PVC or the VLAN ID number assigned to traffic sent through this connection. Type Rate (null) means the entry is not valid. This shows the method of encapsulation used by this connection. This shows the maximum data rate (in Kbps) allowed for traffic sent through this connection. This displays N/A when there is no limit on transmission rate. 80 P-870HN-5xb User's Guide