Brother International MFC-9200C Users Manual - English - Page 41

Connections Do not connect a TAD elsewhere on the same phone line. 1 Plug the telephone line cord from the wall jack into the left side of the MFC, in the jack labeled LINE. 2 Plug the telephone line cord from your TAD into the left side of the MFC, in the jack labeled EXT. (Make sure this cord is connected to the TAD at the TAD's telephone line jack, and not its telephone set jack.) 3 Set your external TAD to four rings or less. Two rings are recommended. (The MFC's Ring Delay setting does not apply.) 4 Record the outgoing message. (See below.) 5 Set the Receive Mode to EXT. TEL/TAD. (See Select Receive Mode, page 5-1.) Recording Outgoing Message (OGM) Timing is important in recording this message. The message sets up the ways to handle both manual and automatic fax reception. 1 Record 5 seconds of silence at the beginning of your message. (This allows your MFC time to listen for the fax CNG tones of automatic transmissions before they stop.) 2 Limit your speaking to 20 seconds. 3 End your 20-second message by giving your Fax Receive Code for people sending manual faxes. For example: "After the beep, leave a message or send a fax by pressing 51 and Start." Note We recommend beginning your OGM with an initial 5-second silence because the MFC cannot hear fax tones over a resonant or loud voice. You may try omitting this pause, but if your MFC has trouble receiving, then you must rerecord the OGM to include it. A S S E M B L Y A N D C O N N E C T I O N S 2 - 13