Canon PIXMA MX320 On-Screen Manual - Page 750

Error Message Appears on a PictBridge Compliant Device Page 750 of 817 pages Advanced Guide > Troubleshooting > Error Message Appears on a PictBridge Compliant Device Error Message Appears on a PictBridge Compliant Device The following are the possible errors that may occur when printing directly from a PictBridge compliant device and the countermeasures to clear them. Note This section describes errors that are indicated on Canon-brand PictBridge compliant devices. The error messages and operations may vary depending on the device you are using. For errors on non -Canon PictBridge compliant devices, check the error message on the LCD and take the appropriate action to clear the error. For details, see An Error Message Is Displayed on the LCD . For the errors indicated on the PictBridge compliant device and their solution, also refer to the instruction manual of the device. For other troubles on the device, contact the manufacturer. Error Message on the PictBridge Compliant Device "Printer in use" "No paper" "Paper Error" "Paper jam" "Printer cover open" "No print head" "Waste tank full"/"Ink absorber full" "No ink"/"Ink cassette error" "Hardware Error" "Printer error" Action If the machine is printing from the computer or warming up, wait until the job ends. When it is ready, the machine starts printing automatically. Load paper on the Rear Tray, and select Continue* in the display on your PictBridge compliant device. * To resume printing, you can also press the OK button on the machine instead of selecting Continue on the device. The Paper Output Tray is closed. Open the Paper Output Tray, then press the OK button on the machine. Select Stop in the display on your PictBridge compliant device to stop printing. Remove the jammed paper, load new paper, press the OK button on the machine, and try printing again. Close the Scanning Unit (Cover) on the machine. The FINE Cartridge is not installed or the Cartridge may not be compatible with this machine. Check: See Check inkU051/U052/U053/U059 in An Error Message Is Displayed on the LCD and take the appropriate action. The ink absorber is nearly full. Check: See Contact service center in An Error Message Is Displayed on the LCD and take the appropriate action. The FINE Cartridge has or may have run out of ink. The FINE Cartridge may not be installed properly or may not be compatible with this machine. Check the error message on the LCD and take the appropriate action to resolve the error. An Error Message Is Displayed on the LCD FINE Cartridge errors have occurred. Replace the FINE Cartridge. Routine Maintenance An error requiring servicing may have occurred. (The Power lamp flashes green and Alarm lamp flashes orange alternately.) Disconnect the USB cable between the machine and the PictBridge compliant device, turn off the machine, and unplug the power cord of the machine from the power supply. Plug the power cord of the machine back in, turn on the machine, and then reconnect the PictBridge compliant