Cisco SRP521W-K9-G1 Administration Guide - Page 107

Configuring Voice Configuring Dial Plans 6 Terminating Event Processing The dialed digits exactly • If the sequence is allowed by the dial plan, the match one sequence in number is accepted and is transmitted according the dial plan. to the dial plan. • If the sequence is blocked by the dial plan, the number is rejected. A timeout occurs. The number is rejected if the dialed digits are not matched to a digit sequence in the dial plan within the time specified by the applicable interdigit timer. • The Interdigit Long Timer applies when the dialed digits do not match any digit sequence in the dial plan. The default value is 10 seconds. • The Interdigit Short Timer applies when the dialed digits match one or more candidate sequences in the dial plan. The default value is 3 seconds. The user presses the # key. • If the sequence is complete and is allowed by the dial plan, the number is accepted and is transmitted according to the dial plan. • If the sequence is incomplete or is blocked by the dial plan, the number is rejected. Dial Plan Timer (Off-Hook Timer) You can think of the Dial Plan Timer as "the off-hook timer." This timer starts counting when the phone goes off hook. If no digits are dialed within the specified number of seconds, the timer expires and the null entry is evaluated. Unless you have a special dial plan string to allow a null entry, the call is rejected. The default value is 5. Syntax for the Dial Plan Timer SYNTAX: (Ps | dial plan ) • s: The number of seconds; if no number is entered after P, the default timer of 5 seconds applies. • n: (optional): The number to transmit automatically when the timer expires; you can enter a valid number. No wildcard characters are allowed because the number will be transmitted as shown. If you omit the number Cisco SRP500 Series Services Ready Platforms Administration Guide (SRP520 Models) 107