Cisco SRP521W-K9-G1 Administration Guide - Page 132
Resync From SIP, Resync Error Retry
View all Cisco SRP521W-K9-G1 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 132 highlights
6 132 Configuring Voice Configuring Voice Settings Resync Periodic Resync Error Retry Delay Forced Resync Delay Resync From SIP Resync After Upgrade Attempt The time interval between periodic resyncs with the provisioning server. The associated resync timer is active only after the first successful sync with the server. Set this parameter to zero to disable periodic resyncing. The default is 3600 seconds. Resync retry interval (in seconds) applied in case of resync failure. The device has an error retry timer that activates if the previous attempt to sync with the provisioning server fails. The device waits to contact the server again until the timer counts down to zero. This parameter is the value that is initially loaded into the error retry timer. If this parameter is set to zero, the device immediately retries to sync with the provisioning server following a failed attempt. The default is 3600 seconds. Maximum delay (in seconds) the SPA waits before performing a resync. The device does not resync while one of its phone lines is active. Because a resync can take several seconds, it is desirable to wait until the device has been idle for an extended period before resyncing. This allows a user to make calls in succession without interruption. The device has a timer that begins counting down when all of its lines become idle. This parameter is the initial value of the counter. Resync events are delayed until this counter decrements to zero. The default is 14,400 seconds. Enables a resync to be triggered via a SIP NOTIFY message. The default is Yes. Triggers a resync after every firmware upgrade attempt. The default is Yes. Cisco SRP500 Series Services Ready Platforms Administration Guide (SRP520 Models)