Cisco SRP521W-K9-G1 Administration Guide - Page 75

Configuring the Network Firewall 5 DSCP To Queue Use the DSCP to Queue page to queue traffic based on the Differentiated Services Code Point (DSCP) value in the incoming packet. STEP 1 Click Network Setup > QoS > DSCP To Queue. The DSCP To Queue window opens. STEP 2 Change the priority settings for each IP DiffServ value as necessary. STEP 3 Choose a priority level from the drop-down list. The priority defines the traffic forwarding queue to which traffic with the given DSCP is mapped. The available priorities are Strict, High, Medium, Normal, and Low. STEP 4 Click Submit to save your settings. Firewall This section describes how to configure the firewall settings for the SRP. It includes the following sections: • Firewall Filter • Internet Access Control To access these pages click Network Setup > Firewall from the Configuration Utility. Firewall Filter Use the Firewall Filter page to enable firewall protection filtering on the SRP. The firewall enhances network security and uses Stateful Packet Inspection (SPI) to analyze data packets entering your network. STEP 1 Click Network Setup > Firewall > Firewall Filter. The Firewall window opens. STEP 2 Select Enabled to enable SPI firewall protection. The firewall is enabled by default. STEP 3 Specify the Internet and Web Filter Options as specified in the Firewall Filter Settings table. Cisco SRP500 Series Services Ready Platforms Administration Guide (SRP520 Models) 75