Cisco SRP521W-K9-G1 Administration Guide - Page 152
Block Caller ID *67., Feature Dial
View all Cisco SRP521W-K9-G1 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 152 highlights
6 152 Configuring Voice Configuring Voice Settings Feature Dial Services Codes These codes tell the SRP what to do when the user is listening to the first or second dial tone. One or more *code can be configured into this parameter, such as *72, or *72|*74|*67|*82, etc. Max total length is 79 chars. This parameter applies when the user has a dial tone (first or second dial tone). Enter *code (and the following target number according to current dial plan) entered at the dial tone triggers the SRP to call the target number prepended by the *code. For example, after user dials *72, the SRP plays a special tone called a Prompt tone while awaiting the user to enter a valid target number. When a complete number is entered, the SRP sends a INVITE to *72 target_number as in a normal call. This feature allows the proxy to process features like call forward (*72) or Block Caller ID (*67). The *codes should not conflict with any of the other vertical service codes internally processed by the SRP. You can empty the corresponding *code that you do not want to the SRP to process. You can add a parameter to each *code in Features Dial Services Codes to indicate what tone to play after the *code is entered, such as *72'c'|*67'p'. Below are a list of allowed tone parameters (note the use of open quotes surrounding the parameter w/o spaces) 'c' = 'd' = 'm' = 'o' = 'p' = 's' = 'x' = No tones are place, x is any digit not used above If no tone parameter is specified, the SRP plays Prompt tone by default. If the *code is not to be followed by a phone number, such as *73 to cancel call forwarding, do not include it in this parameter. In that case, simply add that *code in the dial plan and the SRP send INVITE *73@..... as usual when user dials *73. Cisco SRP500 Series Services Ready Platforms Administration Guide (SRP520 Models)