Cisco SRP521W-K9-G1 Administration Guide - Page 86
Configuring the Network, CDP Settings, Field, Description, CDP Hold Timer
View all Cisco SRP521W-K9-G1 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 86 highlights
Configuring the Network CDP Setting 5 CDP Settings Field CDP CDP Timer CDP Hold Timer Interface List Description Control whether CDP will run on some, all or none of the SRP Ethernet interfaces. CDP per port is the default setting (recommended). Specify the interval at which successive CDP packets can be sent. You can enter a value between 5 to 900 seconds. The default is 60 seconds. Control whether CDP will run on some, all or none of the SRP Ethernet interfaces. Enter a value between 10 to 255 seconds. The default value is 80 seconds. Check the enable box to select which interfaces will run CDP. Cisco SRP500 Series Services Ready Platforms Administration Guide (SRP520 Models) 86
Configuring the Network
CDP Setting
Cisco SRP500 Series Services Ready Platforms Administration Guide (SRP520 Models)
86
5
CDP Settings
Field
Description
CDP
Control whether CDP will run on some, all or none of the
SRP Ethernet interfaces
.
CDP per port is the default
setting (recommended).
CDP Timer
Specify the interval at which successive CDP packets
can be sent. You can enter a value between 5 to 900
seconds. The default is 60 seconds.
CDP Hold Timer
Control whether CDP will run on some, all or none of the
SRP Ethernet interfaces
.
Enter a value between 10 to
255 seconds. The default value is 80 seconds.
Interface List
Check the enable box to select which interfaces will run
CDP.