Cisco SRP521W-K9-G1 Administration Guide - Page 145

Configuring Voice Configuring Voice Settings 6 Hook Flash Timer Max Maximum on-hook time before off-hook qualifies as hookflash. More than this the on-hook event is treated as onhook (no hook-flash event). Range: 0.4-1.6 seconds. The default is 0.9. Callee On Hook Delay Phone must be on-hook for at this time in sec. before the SRP will tear down the current inbound call. It does not apply to outbound calls. Range: 0-255 seconds. The default is 0. Reorder Delay Delay after far end hangs up before reorder tone is played. 0 = plays immediately, inf = never plays. Range: 0-255 seconds. The default is 5. Call Back Expires Expiration time in seconds of a call back activation. Range: 0-65535 seconds. The default is 1800. Call Back Retry Intvl Call back retry interval in seconds. Range: 0-255 seconds. The default is 30. Call Back Delay Delay after receiving the first SIP 18x response before declaring the remote end is ringing. If a busy response is received during this time, the SRP still considers the call as failed and keeps on retrying. The default is 0.5. VMWI Refresh Intvl Interval between VMWI refresh to the CPE. The default is 0. Interdigit Long Timer Long timeout between entering digits when dialing. The interdigit timer values are used as defaults when dialing. The Interdigit_Long_Timer is used after any one digit, if all valid matching sequences in the dial plan are incomplete as dialed. Range: 0-64 seconds. The default is 10. Cisco SRP500 Series Services Ready Platforms Administration Guide (SRP520 Models) 145