Cisco SRP521W-K9-G1 Administration Guide - Page 144
Ring and Call Waiting Tone Spec, Control Timer Values sec
View all Cisco SRP521W-K9-G1 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 144 highlights
6 144 Configuring Voice Configuring Voice Settings Ring and Call Waiting Tone Spec IMPORTANT: Ring and Call Waiting tones do not work the same way on all phones. When setting ring tones, consider the following recommendations: • Begin with the default Ring Waveform, Ring Frequency, and Ring Voltage. • If your ring cadence doesn't sound right, or your phone doesn't ring, change your Ring Waveform, Ring Frequency, and Ring Voltage to the following: - Ring Waveform: Sinusoid - Ring Frequency: 25 - Ring Voltage: 80Vc Ring Waveform Waveform for the ringing signal. Choices are Sinusoid or Trapezoid. The default is Trapezoid. Ring Frequency Frequency of the ringing signal. Valid values are 10-100 (Hz). The default is 20. Ring Voltage Ringing voltage. Choices are 60-90 (V). The default is 85. CWT Frequency Frequency script of the call waiting tone. All distinctive CWTs are based on this tone. The default is 440@-10. Synchronized Ring If this is set to Yes, when the SRP is called, all lines ring at the same time (similar to a regular PSTN line). After one line answers, the others stop ringing. The default is no. Control Timer Values (sec) Voice > Regional > Control Timer Values (sec) Hook Flash Timer Min Minimum on-hook time before off-hook qualifies as hookflash. Less than this the on-hook event is ignored. Range: 0.1-0.4 seconds. The default is 0.1. Cisco SRP500 Series Services Ready Platforms Administration Guide (SRP520 Models)