Cisco SRP521W-K9-G1 Administration Guide - Page 150

6 150 Configuring Voice Configuring Voice Settings CWCID Deact Code Disables call waiting, caller ID generation. The default is *45. Dist Ring Act Code Enables the distinctive ringing feature. The default is *26. Dist Ring Deact Code Disables the distinctive ringing feature. The default is *46. Speed Dial Act Code Assigns a speed dial number. The default is *74. Paging Code Used for paging other clients in the group. The default is *96. Secure All Call Act Code Makes all outbound calls secure. The default is *16. Secure No Call Act Code Makes all outbound calls not secure. The default is *17. Secure One Call Act Code Makes the next outbound call secure. (It is redundant if all outbound calls are secure by default.) The default is *18. Secure One Call Deact Code Makes the next outbound call not secure. (It is redundant if all outbound calls are not secure by default.) The default is *19. Conference Act Code If this code is specified, the user must enter it before dialing the third party for a conference call. Enter the code for a conference call. Attn-Xfer Act Code If the code is specified, the user must enter it before dialing the third party for a call transfer. Enter the code for a call transfer. Modem Line Toggle Code Toggles the line to a modem. The default is *99. Modem pass-through mode can be triggered only by pre-dialing this code. Cisco SRP500 Series Services Ready Platforms Administration Guide (SRP520 Models)