Cisco SRP521W-K9-G1 Administration Guide - Page 140

6 140 Configuring Voice Configuring Voice Settings SIT2 Tone SIT3 Tone SIT4 Tone MWI Dial Tone Cfwd Dial Tone Holding Tone Conference Tone Secure Call Indication Tone Alternative to the Reorder Tone played when an error occurs as a caller makes an outbound call. The RSC to trigger this tone is configurable on the SIP screen. The default is 914@-16,1371@-16,1777@ 16;20(.274/0/ 1,.274/0/2,.380/0/3,0/4/0). Alternative to the Reorder Tone played when an error occurs as a caller makes an outbound call. The RSC to trigger this tone is configurable on the SIP screen. The default is 914@-16,1371@-16,1777@-16;20(.380/0/ 1,.380/0/2,.380/0/3,0/4/0). Alternative to the Reorder Tone played when an error occurs as a caller makes an outbound call. The RSC to trigger this tone is configurable on the SIP screen. The default is 985@-16,1371@-16,1777@-16;20(.380/0/ 1,.274/0/2,.380/0/3,0/4/0). Played instead of the Dial Tone when there are unheard messages in the caller's mailbox. The default is: 350@-19,440@-19;2(.1/.1/1+2);10(*/0 1+2). Played when all calls are forwarded. The default is: 350@-19,440@-19;2(.2/.2/1+2);10(*/0/1+2). Informs the local caller that the far end has placed the call on hold. The default is 600@-19*(.1/.1/1,.1/.1/1,.1/9.5/1). Played to all parties when a three-way conference call is in progress. The default is 350@-19;20(.1/.1/1,.1/9.7/1). Played when a call has been successfully switched to secure mode. It should be played only for a short while (less than 30 seconds) and at a reduced level (less than -19 dBm) so it does not interfere with the conversation. The default is 397@-19,507@-19;15(0/2/0,.2/.1/1,.1/2.1/2). Cisco SRP500 Series Services Ready Platforms Administration Guide (SRP520 Models)