Cisco SRP521W-K9-G1 Administration Guide - Page 58

Setting up the Interfaces of the Services Ready Platforms Setting up the Wireless LAN 4 Advanced Wireless Settings Use the Wireless Settings page to configure advanced wireless functions for the SRP. NOTE These settings should only be configured by an experienced administrator. Before you configure these settings, make sure that wireless is enabled on the SRP. See Basic Wireless Settings, page 49. STEP 1 Click Interface Setup > Wi-Fi Settings > Advanced Wireless Settings. The Advanced Wireless window opens. STEP 2 To configure the RTS Threshold select an SSID from the drop-down list. STEP 3 Enter a value in the RTS Threshold field. If you encounter inconsistent data flow, enter only minor reductions. The default value of 2347 is recommended. STEP 4 Change any settings in the Global Settings area as defined in the Advanced Wireless Settings table. Click Submit to save your settings. Advanced Wireless Settings Field Description Advanced Wireless Setup Select a SSID Choose the name of the wireless network that you want to configure. The default data SSID is cisco-data. The default voice SSID is cisco-voice. RTS Threshold The SRP sends Request to Send (RTS) frames to a receiving station and negotiates the sending of a data frame. After receiving an RTS, the wireless station responds with a Clear to Send (CTS) frame to acknowledge the right to begin transmission. If you encounter inconsistent data flow, you can adjust this threshold. Only minor reduction of the default value, 2347, is recommended. If a network packet is smaller than the preset RTS threshold size, the RTS/CTS mechanism will not be enabled. The RTS Threshold value should remain at its default value of 2347. Cisco SRP500 Series Services Ready Platforms Administration Guide (SRP520 Models) 58