Cisco SRP521W-K9-G1 Administration Guide - Page 110

6 Configuring Voice Configuring Dial Plans EXAMPLE: (9,8[2-9]xxxxxx | 9,8,1[2-9]xxxxxxxxxS0 | 9,8,011xx. | 9,8,xx.|[1-8]xx) 9,8,1[2-9]xxxxxxxxxS0 With the timer set to 0, the call is transmitted automatically when the user dials the final digit in the sequence. Editing Dial Plans You can edit dial plans and can modify the control timers. Entering the Line Interface Dial Plan This dial plan is used to strip steering digits from a dialed number before it is transmitted out to the carrier. STEP 1 Log in to the Configuration Utility. If prompted, enter the administrative logon provided by the Service Provider. The default username and password are both admin. STEP 2 Under the Voice menu, click the Line (Line 1-2) to choose the line interface that you want to modify. STEP 3 Scroll down to the Dial Plan section. STEP 4 Enter the digit sequences in the Dial Plan field. For more information, see About Dial Plans, page 102. STEP 5 Click Submit to save your settings. Resetting the Control Timers You can use the following procedure to reset the default timer settings for all calls. NOTE To edit a timer setting only for a particular digit sequence or type of call, you can edit the dial plan. See About Dial Plans, page 102. STEP 1 Log in to the Configuration Utility. If prompted, enter the administrative logon provided by the Service Provider. The default username and password are both admin. STEP 2 Under the Voice menu, click Regional. 110 Cisco SRP500 Series Services Ready Platforms Administration Guide (SRP520 Models)