Cisco SRP521W-K9-G1 Administration Guide - Page 109

Configuring Voice Configuring Dial Plans 6 Syntax for the Interdigit Long Timer SYNTAX: L:s, ( dial plan ) s: The number of seconds; if no number is entered after L:, the default timer of 5 seconds applies. The timer sequence appears to the left of the initial parenthesis for the dial plan. Example for the Interdigit Long Timer EXAMPLE: L:15, (9,8[2-9]xxxxxx | 9,8,1[2-9]xxxxxxxxx | 9,8,011xx. | 9,8,xx.|[1-8]xx) L:15, This dial plan allows the user to pause for up to 15 seconds between digits before the Interdigit Long Timer expires. Interdigit Short Timer (Complete Entry Timer) You can think of this timer as the "complete entry" timer. This timer measures the interval between dialed digits. It applies when the dialed digits match at least one digit sequence in the dial plan. Unless the user enters another digit within the specified number of seconds, the entry is evaluated. If it is valid, the call proceeds. If it is invalid, the call is rejected. The default value is 3 seconds. Syntax for the Interdigit Short Timer SYNTAX 1: S:s, ( dial plan ) Use this syntax to apply the new setting to the entire dial plan within the parentheses. • SYNTAX 2: sequence Ss Use this syntax to apply the new setting to a particular dialing sequence. s: The number of seconds; if no number is entered after S, the default timer of 5 seconds applies. Examples for the Interdigit Short Timer • Set the timer for the entire dial plan. EXAMPLE: S:6,(9,8[2-9]xxxxxx | 9,8,1[2-9]xxxxxxxxx | 9,8,011xx. | 9,8,xx.|[1-8]xx) S:6, While entering a number with the phone off hook, a user can pause for up to 15 seconds between digits before the Interdigit Short Timer expires. . • Set an instant timer for a particular sequence within the dial plan. Cisco SRP500 Series Services Ready Platforms Administration Guide (SRP520 Models) 109