Dell Latitude 7030 Rugged Extreme Tablet Owners Manual - Page 100
Installing the fan and heat-sink assembly
View all Dell Latitude 7030 Rugged Extreme Tablet manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 100 highlights
Figure 85. Installing the fan and heat-sink assembly Steps 1. Align the screw holes on the fan and heat-sink assembly with the screw holes on the system board. 2. Tighten the four captive screws to secure the fan and heat-sink assembly to the system board. NOTE: Tighten the four captive screws in the sequential order mentioned on the heat sink [1 > 2 > 3 > 4]. 3. Replace the screw (M2x6) to secure the fan and heat-sink assembly to the display assembly. 4. Connect the fan cable to the connector on the system board. 5. Align and place the system-board shielding cover, along with wireless-card thermal plate on the system board and continue working along the bottom side of the system-board shielding cover until it clicks in place. NOTE: The wireless-card thermal plate is permanently attached to the system-board shielding cover. Any replacement of the wireless card requires removal of the system-board shielding cover along with the wireless-card thermal plate. 6. Adhere the tape to secure the display cable to the system-board shielding cover. 7. Adhere the tape to secure the fan cable to the system-board shielding cover. 8. Align and place the wireless-card bracket on the system board. 9. Tighten the captive screw to secure the wireless-card bracket to the wireless card. 100 Removing and installing Field Replaceable Units (FRUs)