Dell Latitude 7030 Rugged Extreme Tablet Owners Manual - Page 99
Installing the fan and heat-sink assembly
View all Dell Latitude 7030 Rugged Extreme Tablet manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 99 highlights
Figure 84. Removing the fan and heat-sink assembly 6. Carefully lift the system-board shielding cover, along with wireless-card thermal plate, off the display assembly. 7. Using a plastic scribe, disconnect the fan cable from the connector on the system board. 8. Remove the screw (M2x6) that secures the fan and heat-sink assembly to the display assembly. 9. Loosen the four captive screws that secure the fan and heat-sink assembly to the system board. NOTE: Loosen the four captive screws in the reverse sequential order mentioned on the heat sink [4 > 3 > 2 > 1]. 10. Remove the fan and heat-sink assembly from the display assembly. NOTE: Technicians must carefully pull the rubber stopper out of the slot to avoid damage to the fan and heat-sink assembly when removing the fan and heat-sink assembly from the display assembly. Installing the fan and heat-sink assembly CAUTION: The information in this installation section is intended for authorized service technicians only. Prerequisites If you are replacing a component, remove the existing component before performing the installation procedure. About this task The following images indicate the location of the fan and heat-sink assembly and provide a visual representation of the installation procedure. Removing and installing Field Replaceable Units (FRUs) 99