Dell Latitude 7030 Rugged Extreme Tablet Owners Manual - Page 76
Installing the world-facing camera, Removing the world-facing camera
View all Dell Latitude 7030 Rugged Extreme Tablet manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 76 highlights
Figure 64. Removing the world-facing camera Steps 1. Remove the three screws (M2x3) that secure the camera-connector bracket to the system board. 2. Lift the camera-connector bracket off the system board. 3. Using a plastic scribe, disconnect the world-facing camera FPC from the connector on the system board. 4. Remove the two screws (M2x3) that secure the world-facing camera to the front camera and microphone assembly. 5. Remove the world-facing camera from the front camera and microphone assembly. Installing the world-facing camera CAUTION: The information in this installation section is intended for authorized service technicians only. NOTE: This procedure applies only to tablets shipped with a world-facing camera installed. Prerequisites If you are replacing a component, remove the existing component before performing the installation procedure. 76 Removing and installing Field Replaceable Units (FRUs)