Dell Latitude 7030 Rugged Extreme Tablet Owners Manual - Page 73
Installing the wireless card, Steps
View all Dell Latitude 7030 Rugged Extreme Tablet manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 73 highlights
Steps 1. Loosen the captive screw that secures the wireless-card bracket to the wireless card. 2. Lift the wireless-card bracket off the wireless card. 3. Peel back the tape that secures the fan cable to the system-board shielding cover. 4. Peel back the tape that secures the display cable to the system-board shielding cover. 5. Using a plastic scribe, release the system-board shielding cover starting from the release point near the fan-cable connector, on the top side of the tablet. Continue working along the bottom side of the system-board shielding cover. NOTE: The wireless-card thermal plate is permanently attached to the system-board shielding cover. Any replacement of the wireless card requires removal of the system-board shielding cover along with the wireless-card thermal plate. Figure 62. Removing the wireless card 6. Carefully lift the system-board shielding cover, along with wireless-card thermal plate, off the display assembly. 7. Disconnect the wireless-antenna cables from the connectors on the wireless card. 8. Slide and remove the wireless card from the wireless-card slot on the system board. Installing the wireless card CAUTION: The information in this installation section is intended for authorized service technicians only. Prerequisites If you are replacing a component, remove the existing component before performing the installation procedure. About this task The following images indicate the location of the wireless card and provide a visual representation of the installation procedure. Removing and installing Field Replaceable Units (FRUs) 73