Dell Latitude 7030 Rugged Extreme Tablet Owners Manual - Page 123
Display assembly, Removing the display assembly
View all Dell Latitude 7030 Rugged Extreme Tablet manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 123 highlights
Figure 107. Installing the coin-cell battery Steps 1. Flip the system board to access the coin-cell battery slot. 2. Adhere the coin-cell battery to the system board. 3. Connect the coin-cell battery cable to the connector on the system board. Next steps 1. Install the system board. 2. Install the WWAN-card heat-sink. 3. Install the blank top-cover, or the RJ45-port assembly, or the USB-port assembly, or the audio-jack assembly, or the 1D-2D barcode-scanner assembly, whichever is applicable. 4. Install the wireless card. 5. Install the I/O daughter-board. 6. Install the back-cover assembly. 7. Install the SIM card (for hot-swappable batteries), if applicable. 8. Install the hot-swappable batteries, if applicable. 9. Install the handle, if applicable. 10. Install the stylus. 11. Follow the procedure in After working inside your tablet. Display assembly Removing the display assembly CAUTION: The information in this removal section is intended for authorized service technicians only. Prerequisites 1. Follow the procedure in Before working inside your tablet. 2. Remove the stylus. Removing and installing Field Replaceable Units (FRUs) 123