Dell Latitude 7030 Rugged Extreme Tablet Owners Manual - Page 83
Installing the RJ45-port assembly
View all Dell Latitude 7030 Rugged Extreme Tablet manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 83 highlights
Installing the RJ45-port assembly CAUTION: The information in this installation section is intended for authorized service technicians only. NOTE: This procedure applies only to tablets shipped with an RJ45 connector installed in the expansion bay at the top side of the tablet. Prerequisites If you are replacing a component, remove the existing component before performing the installation procedure. About this task The following images indicate the location of the RJ45-port assembly and provide a visual representation of the installation procedure. Figure 71. Installing the RJ45-port assembly Steps 1. Align and place the RJ45-port assembly on the display assembly. 2. Align the screw holes on the RJ45-port cover with the screw holes on the RJ45-port assembly. 3. Replace the four screws (M2x6) to secure the RJ45-port cover to the RJ45-port assembly. Removing and installing Field Replaceable Units (FRUs) 83