Dell Latitude 7030 Rugged Extreme Tablet Owners Manual - Page 154
Table 52. System-diagnostic lights continued, Blinking pattern, Problem description
View all Dell Latitude 7030 Rugged Extreme Tablet manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 154 highlights
Table 52. System-diagnostic lights (continued) Blinking pattern Amber Green 2 3 2 4 2 5 2 6 2 7 2 8 3 1 3 2 3 3 3 4 3 5 3 6 Problem description Suggested resolution No memory/RAM detected ● Confirm that the memory module is installed properly. ● If the problem persists, replace the memory module. Memory/RAM failure ● Reset and swap memory modules among the slots. ● If the problem persists, replace the memory module. Invalid memory installed ● Reset and swap memory modules among the slots. ● If the problem persists, replace the memory module. System board/Chipset Error Replace the system board. LCD failure (SBIOS message) Replace the LCD module. LCD failure (EC detection of power rail failure) Replace the system board. CMOS battery failure ● Reset the main battery connection. ● If the problem persists, replace the main battery. PCI or Video card/chip failure Replace the system board. BIOS Recovery image not found ● Flash latest BIOS version. ● If the problem persists, replace the system board. BIOS Recovery image found ● Flash latest BIOS version. but invalid ● If the problem persists, replace the system board. Power rail failure Replace the system board. Flash corruption detected by ● SBIOS Press the power button for over 25 seconds to do RTC reset. If the problem persists, replace the system board. ● Disconnect all power source (AC, battery, coin cell) and drain flea power by pressing and holding down the power button 3~5 seconds to ensure all power are drained. ● Run "BIOS recovery from USB", and the instructions are in the website Dell support. ● If the problem persists, replace the system board. 154 Troubleshooting