Dell Latitude 7030 Rugged Extreme Tablet Owners Manual - Page 85
Installing the USB-port assembly, Removing the USB-port assembly
View all Dell Latitude 7030 Rugged Extreme Tablet manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 85 highlights
Figure 72. Removing the USB-port assembly Steps 1. Remove the two screws (M1x2.65) that secure the USB-port daughter-board to the system board. 2. Using a plastic scribe, disconnect the USB-port daughter-board from the connector on the system board. 3. Remove the four screws (M2x6) that secure the USB-port cover to the USB-port assembly. 4. Remove the USB-port cover from the display assembly. 5. Carefully remove the USB-port assembly from the display assembly. NOTE: Technicians must carefully pull the rubber stopper out of the slot to avoid damage to the USB-port assembly FPC when removing the USB-port assembly from the display assembly. Installing the USB-port assembly CAUTION: The information in this installation section is intended for authorized service technicians only. NOTE: This procedure applies only to tablets shipped with a USB connector installed in the expansion bay at the top side of the tablet. Removing and installing Field Replaceable Units (FRUs) 85