Dell Latitude 7030 Rugged Extreme Tablet Owners Manual - Page 88
Installing the audio-jack assembly, Removing the audio-jack assembly
View all Dell Latitude 7030 Rugged Extreme Tablet manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 88 highlights
Figure 74. Removing the audio-jack assembly Steps 1. Remove the two screws (M1x2.65) that secure the audio-jack daughter-board to the system board. 2. Using a plastic scribe, disconnect the audio-jack daughter-board from the connector on the system board. 3. Remove the four screws (M2x6) that secure the audio-jack cover to the audio-jack assembly. 4. Remove the audio-jack cover from the display assembly. 5. Carefully remove the audio-jack assembly from the display assembly. NOTE: Technicians must carefully pull the rubber stopper out of the slot to avoid damage to the audio-jack assembly FPC when removing the audio-jack assembly from the display assembly. Installing the audio-jack assembly CAUTION: The information in this installation section is intended for authorized service technicians only. NOTE: This procedure applies only to tablets shipped with an audio-jack connector installed in the expansion bay at the top side of the tablet. 88 Removing and installing Field Replaceable Units (FRUs)