Dell PowerVault NX3500 Hardware Owner's Manual - Page 40

Link Width is, Actual Link Width

Get Dell PowerVault NX3500 PDF manuals and user guides View all Dell PowerVault NX3500 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 40 highlights

Table 1-4. System Messages (continued) Message Causes Memory tests terminated by keystroke. POST memory test was terminated by pressing the spacebar. MEMTEST lane failure detected on x. Invalid memory configuration. Mismatched memory modules are installed. No boot device available. Faulty or missing optical drive subsystem, hard drive, or hard drive subsystem, or no bootable USB key installed. No boot sector on Incorrect configuration hard drive. settings in System Setup program, or no operating system on hard drive. No timer tick interrupt. Faulty system board. PCIe Training Faulty or improperly Error: Expected installed PCIe card in the Link Width is x, specified slot. Actual Link Width is y. Corrective Actions Information only. Ensure that the memory modules are installed in a valid configuration. See "General Memory Module Installation Guidelines" on page 67. Use a bootable USB key, optical drive, or hard drive. If the problem persists, see "Troubleshooting an Optical Drive" on page 99, and "Troubleshooting a Hard Drive" on page 100. Check the hard drive configuration settings in the System Setup program. If necessary, install the operating system on your hard drive. See your operating system documentation. See "Getting Help" on page 113. Reseat the PCIe card in the specified slot number. See "Troubleshooting an Expansion Card" on page 101. If the problem persists, see "Getting Help" on page 113. 40 About Your Solution

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
  • 81
  • 82
  • 83
  • 84
  • 85
  • 86
  • 87
  • 88
  • 89
  • 90
  • 91
  • 92
  • 93
  • 94
  • 95
  • 96
  • 97
  • 98
  • 99
  • 100
  • 101
  • 102
  • 103
  • 104
  • 105
  • 106
  • 107
  • 108
  • 109
  • 110
  • 111
  • 112
  • 113
  • 114
  • 115
  • 116
  • 117
  • 118
40
About Your Solution
Memory tests
terminated by
keystroke.
POST memory test was
terminated by pressing the
spacebar.
Information only.
MEMTEST lane
failure detected
on
x.
Invalid memory
configuration. Mismatched
memory modules are
installed.
Ensure that the memory
modules are installed in a
valid configuration.
See "General Memory
Module Installation
Guidelines" on page 67.
No boot device
available.
Faulty or missing optical
drive subsystem, hard drive,
or hard drive subsystem, or
no bootable USB key
installed.
Use a bootable USB key,
optical drive, or hard drive.
If the problem persists,
see "Troubleshooting an
Optical Drive" on page 99,
and "Troubleshooting a Hard
Drive" on page 100.
No boot sector on
hard drive.
Incorrect configuration
settings in System Setup
program, or no operating
system on hard drive.
Check the hard drive
configuration settings in the
System Setup program.
If necessary, install the
operating system on your
hard drive. See your
operating system
documentation.
No timer tick
interrupt.
Faulty system board.
See "Getting Help" on
page 113.
PCIe Training
Error: Expected
Link Width is
x
,
Actual Link Width
is
y
.
Faulty or improperly
installed PCIe card in the
specified slot.
Reseat the PCIe card in the
specified slot number.
See "Troubleshooting an
Expansion Card" on
page 101. If the problem
persists, see "Getting Help"
on page 113.
Table 1-4.
System Messages
(continued)
Message
Causes
Corrective Actions