Dell PowerVault NX3500 Hardware Owner's Manual - Page 98
See General Memory Module Installation Guidelines
View all Dell PowerVault NX3500 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 98 highlights
1 If the system is operational, run the appropriate online diagnostic test. See "Running the System Diagnostics" on page 105. If diagnostics indicates a fault, follow the corrective actions provided by the diagnostic program. 2 If the system is not operational, turn off the system and attached peripherals, and unplug the system from the power source. Wait at least 10 seconds and then reconnect the system to power. 3 Turn on the system and attached peripherals and note the messages on the screen. Go to step 12 if an error message appears indicating a fault with a specific memory module. 4 Enter the System Setup program and check the system memory setting. Make any changes to the memory settings, if needed. If the memory settings match the installed memory but a problem is still indicated, go to step 12. 5 Turn off the system and attached peripherals, and disconnect the system from the electrical outlet. 6 Open the system. See "Opening the System" on page 52. 7 Check the memory channels and ensure that they are populated correctly. See "General Memory Module Installation Guidelines" on page 67. 8 Reseat the memory modules in their sockets. See "Replacing Memory Modules" on page 67. 9 Close the system. See "Closing the System" on page 53. 10 Reconnect the system to its electrical outlet, and turn on the system and attached peripherals. 11 Enter the System Setup program and check the system memory setting. If the problem is not resolved, proceed with the next step. 12 Turn off the system and attached peripherals, and disconnect the system from the power source. 13 Open the system. See "Opening the System" on page 52. 14 If a diagnostic test or error message indicates a specific memory module as faulty, swap or replace the module. 98 Troubleshooting Your System