HP 1320 Service Manual - Page 172

Troubleshooting postscript (PS) errors NOTE The following situations are PS language specific and might occur when several printer languages are being used. To receive a printed or screen displayed message when PS errors occur, open the Print Options dialog box and click the desired selection next to the PS Errors section. You can also access this from the embedded Web server. Table 7-7. PS errors Symptom Possible cause The job prints in Courier (the printer's default typeface) instead of the typeface you requested. The requested typeface is not downloaded. A personality switch might have been performed to print a PCL job just before the PS printing job was received. A legal page prints with clipped Print job too complex. margins. A PS error page prints. Print job might not be PS. Limit Check Error VM Error Range Check Print job is too complex. Font Error Font Error Solution Download the desired font and send the print job again. Verify the type and location of the font. Download to printer if applicable. Check with the software documentation. You might need to print your job at 600 dots per inch, reduce the complexity of the page, or install more memory. Make sure the print job is a PS job. Check to see whether the software application expected a setup or PS header file to be sent to the printer. You might need to print your job at 600 dots per inch, reduce the complexity of the page, or install more memory. Select unlimited downloadable fonts from printer driver. Select unlimited downloadable fonts from printer driver. 160 Chapter 7 Troubleshooting ENWW