HP 7310 User Guide - Page 185
Dial Tone Detection, The HP all-in-one is having problems sending and receiving faxes, Solution
View all HP 7310 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 185 highlights
Chapter 16 phones. Connect your HP all-in-one to an analog phone line and try sending or receiving a fax. After you resolve any problems found, run the fax test again to make sure it passes and your HP all-in-one is ready for faxing. If the Dial Tone Detection test continues to fail, contact your telephone company and have them check the phone line. The HP all-in-one is having problems sending and receiving faxes Solution Note This possible solution applies only in the countries/regions that receive a 2wire phone cord in the box with the HP all-in-one, including: Argentina, Australia, Brazil, Canada, Chile, China, Colombia, Greece, India, Indonesia, Ireland, Japan, Korea, Latin America, Malaysia, Mexico, Philippines, Poland, Portugal, Russia, Saudi Arabia, Singapore, Spain, Taiwan, Thailand, USA, Venezuela, and Vietnam. ● Make sure you used the phone cord supplied in the box with your HP all-in-one to connect to the telephone wall jack. One end of this special 2-wire cord should be connected to the port labeled "1-LINE" on the back of your HP allin-one and the other end to your telephone wall jack, as shown below. Troubleshooting information 1 Telephone wall jack 2 Phone cord supplied in the box with your HP all-in-one This special 2-wire cord is different from the more common 4-wire phone cords you might already have in your home or office. Check the end of the cord and compare it to the two types of cords shown below. If you used the 4-wire phone cord, disconnect it, find the supplied 2-wire cord, and then connect the 2-wire cord to the port labeled "1-LINE" on the back of 182 HP Officejet 7300/7400 series all-in-one